Lighting Research Center Lighting Research Center
    Volume 13 Issue 1
July 2015    
ballast - A device required by electric-discharge light sources such as fluorescent or HID lamps to regulate voltage and current supplied to the lamp during start and throughout operation. compatible ballasts - An abbreviated list of common ballasts that will provide the necessary circuitry for a photosensor to operate correctly. Other ballasts may also be compatible; contact the photosensor manufacturer for details. continuous dimming - Control of a light source's intensity to practically any value within a given operating range. capacitor - A device used in electric circuitry to temporarily store electrical charge in the form of an electrostatic field. In lighting, a capacitor is used to smooth out alternating current from the power supply. time delay range - For motion sensors, the range of time that may be set for the interval between the last detected motion and the turning off of the lamps. lamp - A radiant light source. luminaire - A complete lighting unit consisting of a lamp or lamps and the parts designed to distribute the light, to position and protect the lamp(s), and to connect the lamp(s) to the power supply. (Also referred to as fixture.) frequency - The number of cycles completed by a periodic wave in a given unit of time. Frequency is commonly reported in cycles per second, or hertz (Hz). electromagnetic interference (EMI) - The interference of unwanted electromagnetic signals with desirable signals. Electromagnetic interference may be transmitted in two ways: radiated through space or conducted by wiring. The Federal Communications Commission (FCC) sets electromagnetic interference limits on radio frequency (RF) lighting devices in FCC Part 18. electronic ballast - A ballast that uses electronic components instead of a magnetic core and coil to operate fluorescent lamps. Electronic ballasts operate lamps at 20 to 60 kHz, which results in reduced flicker and noise and increased efficacy compared with ballasts that operate lamps at 60 Hz. illuminance - The amount of light (luminous flux) incident on a surface area. Illuminance is measured in footcandles (lumens/square foot) or lux (lumens/square meter). One footcandle equals 10.76 lux, although for convenience 10 lux commonly is used as the equivalent. dimming ballast - A device that provides the ability to adjust light levels by reducing the lamp current. Most dimming ballasts are electronic. power - The power used by a device to produce useful work (also called input power or active power). In lighting, it is the system input power for a lamp and ballast or driver combination. Power is typically reported in the SI units of watts. photosensor - A device used to integrate an electric lighting system with a daylighting system so lights operate only when daylighting is insufficient. lux (lx) - A measure of illuminance in lumens per square meter. One lux equals 0.093 footcandle. nadir - In the lighting discipline, nadir is the angle pointing directly downward from the luminaire, or 0. Nadir is opposite the zenith. driver - For light emitting diodes, a device that regulates the voltage and current powering the source. photovoltaic (PV) - Photovoltaic (PV) cells produce electric current from light energy (photons). PV cells are joined to make PV panels. hysteresis - The dependence of the output of a system not only on its current input, but also on its history of past inputs. The electric light level set by a photosensor with hysteresis, for a certain photocell input signal, depends on whether that photocell signal is increasing or decreasing. Hysteresis provides stable operation in switching photosensors but is undesirable in dimming photosensors.

References

DiLaura, D. L., K. W. Houser, R. G. Mistrick, G. R. Steffy. 2011. The Lighting Handbook: Reference & Application, 10th Ed. New York, NY: Illuminating Engineering Society.

Jacobs, S. 2013. Power your wireless sensor for 40 years. Electronic Design.  http://electronicdesign.com/power/power-your-wireless-sensors-40-years

National Lighting Product Information Program (NLPIP). 1998. Specifier Reports: Occupancy Sensors. Troy, NY: Lighting Research Center, Rensselaer Polytechnic Institute. http://www.lrc.rpi.edu/nlpip/publicationDetails.asp?id=102

———. 2007. Specifier Reports: Photosensors. Troy, NY: Lighting Research Center, Rensselaer Polytechnic Institute. http://www.lrc.rpi.edu/nlpip/publicationDetails.asp?id=916

Panasonic Corporation. 2012. Gold Capacitor Technical Guide, 7.6 Edition. http://industrial.panasonic.com/jp/i/29880/TGC_E/TGC_E.pdf

RF Explorer. 2015. FAQ: Accuracy, precision and resolution. http://j3.rf-explorer.com/42-rfe/faq/71-accuracy-precision-and-resolution

 

 

Previous
Previous
2015 Rensselaer Polytechnic Institute. All rights reserved. Next Next


Rensselaer Polytechnic Institute
LRC Intranet Web mail Lighting Research Center